Axis Dyno Moto VX-12, User Manual, Page: 32 / 48

Smoothing Box Replacement
Follow these steps:
1. Remove the 8 screws (4 on each end) from the faceplates of the electronics box.
2. Bend the faceplate containing the USB plug down as shown below.
3. Slide the top body of the box off the bottom plate and over the faceplate as shown
below.
4. Disconnect the 4 pin clear connector and remove smoothing box, which is held on with
Velcro.
5. Add Velcro to new smoothing box, place on Labjack, and plug in 4 pin connector.
6. Reassemble electronics box by following steps 1-3 in reverse order.
32