Axis AX1401, Instruction Manual, Page: 6 / 12

EN-6
AUDIO DSP CONTROLS (2)
Press the SEL button again (for more than 2 seconds) to activate Selecting mode for DSP:
2 sec.
SEL BEEP ON / 2nd / OFF
VOL
2 sec.
BEEP SEL SEL FLAT / POP / ROCK / CLASSICAL DSP SEL ADJ
VOL
2 sec.
BEEP SEL SEL
SEL
SEL STEREO SEL LOC DISP SEL
STEREO SEL LOC DISP SEL
2 sec.
SEL STEREO/MONO
VOL
STEREO SEL LOC DISP SEL
2 sec.
SEL DX/LOCAL
VOL
LOC DISP SEL
2 sec.
SEL DISP
STEREO SEL LOC DISP SEL
SEL
ADJ
to set hour to set minute
/
VOL
VOL
VOL
4. PRESET STATIONS (1-6)
Six numbered preset buttons store and recall stations for each band.
Storing a station:
1. Select a band (if needed)
2. Select a station
3. Hold a preset button longer than one second. Preset station number appears in the display when station is
saved.
Recall a station:
1. Select band (if needed)
2. Press a preset button for less than one second to select stored station.
Note: This unit is equipped with built-in memory I.C. (Integrated Circuits) to save user settings such as tuner
preset stations and audio control settings. To cancel these settings, switch to Radio mode, press and hold
button “1” for 2 seconds (do not release button) followed by pressing MD button. Unit will automatically
restart after 5 seconds.
5. MODE / SUBWOOFER BUTTON (MD/SUB)
Press
MD to select between: AUX/TUNER/CD-MP3/USB or MMC/SD modes.
SUBWOOFER: Press and hold this button to engage subwoofer output.
6. BAND SELECTOR / LOUDNESS BUTTON (BD/LD)
Push this switch to select the desired band, either AM or FM.
LOUDNESS: Press and hold the button to select LOUDNESS mode.
7. AUTOMATIC OR MANUAL TUNING (FREQ UP OR FREQ DOWN )
(A) RADIO MODE
When pressed for less than 1 second, these keys operate as SEEK Tuning mode.
When pressed longer than 1 second, they operate as MANUAL tuning mode.
If the keys are not pressed for 3 seconds, they will return to Automatic mode.
(B) CD/MP3 PLAYER MODE
When pressed for less than 1 second, these keys operate as TRACK UP or TRACK DOWN mode.
When pressed longer than 1 second
, they will operate as CUE or REVIEW mode.
8. AUTOMATICALLY STORE STATIONS (A/PS)
Select six strong stations and store them in current band.
1. Select a band (if needed)
2. Hold A/PS button for more than three seconds. The new stations replace stations already stored in that
band.
Preset Scan
Scan stations stored in current band
1. Select a band (if needed)
2. Hold A/PS
for more than one second but less than three seconds. Radio pauses for five seconds at each
station. Press A/PS again to stop scanning when desired station is reached.
9. ACTIVE MATRIX DISPLAY
The Active Matrix Display will display the current state of the unit.
10. OPEN PANEL RELEASE BUTTON ( )
Press button and the front panel will open.