G LM 300
A
170
B
210
C
240
D
210
¾
DEFINITIONS
M A N U A L O P E R ATIO N
Rotate the AUTO/M ANUA L selector carriage release handle by 180
0
,clockwise
Push the on switch/blade start pushbutton
Adjust the thickness you want by turning the slice thickness control knob
Actuate the carriage by your hand
Push the off switch/blade stop pushbutton
A U TO M ATIC O P E R ATIO N
Rotate the AUTO/M ANUA L selector carriage release handle by 180
0
, counterclockwise
Push the on switch/blade start pushbutton
Adjust the thickness you want by turning the slice thickness control knob
Push the product holder start pushbutton
Adjust the length of the stroke by turning the product holder stroke adjustm ent
Push the product holder stop pushbutton to end carriage m ovem ent
Push the off switch bIade stop pushbutton
LU B R IC ATIO N
The rod on which the
produc t holder
slides, which is underneath the slicer, should be lubricated
weekly with several drops of oil. Stop the carriage at the end of the stroke nearest the operator position
and pour the Iubricant into the special oiler. DO NOT use vegetable oil. Occasionally, the slice thickness
plate slide rod should be coated Iightly with lubricant. Turn the slice thickness control fully counterclockwise
when Iubricating this slide rod and then turn it fully clockwise when finished. DO NOT lubricate the rod on
which the
last slice device slides.
It m ust be kept clean but not lubricated. The m otor has sealed
bearings and requires no Iubrication m aintenance.
W E A R A D JU S TM E N T
After several, years of operation and m any sharpenings of the
blad e
it m ay becom e necessary to have
the slice
thickness plate 14
adjusted closer to the blade.
M otors electrical data
W
V
H z
P hase N °
S ervice
A
IP
Degree of
Protection
230
50
220
60
390
120
60
1~
S1
7
33
S licing capacity m m