Installation Instructions
Powering the Axis network camera and housing (no heater)
Note - this installation requires one 230V power cable and 2 x 12V cables (not supplied).
1. Connect the mains power cable to the connector (A) in the power supply.
2. Connect a 12V power cable to the connector (B) in the power supply, pull the 12V cable
through the gland (6) in the housing and connect to the 12V connector (J1).
3. Connect a 12V cable from the connector (J1) to the green connector on the camera (8).
Important! Ensure that the (+) and (-) wires are connected according to the camera
model installed in the housing (see images above).
Proceed with the installation according to the instructions in the Installation Guide
supplied with the camera.
Wiring diagram
PCB
Power supply
PCB
Housing
230V AC in
12V DC
to camera
INSTALL GUIDE VT HOUSING FAN R1.0
PART NO.
25254
Date: July 2005
COPYRIGHT AXIS COMMUNICATIONS AB 2005