4
DRIVING WITHOUT VIDEO DISPLAY (Recommended Installation)
Follow the wiring diagram below so when the vehicle is in motion, no video will display on the LCD screen.
Only sound can be heard from the speaker system. Operation must comply with safety laws in all Australian &
NZ States.
Note:
- Only sound can be heard when car is in motion.
- Refer and follow your country’s law regarding driving with video.
Caution:
- Do not attempt DIY installation if these instructions are not clearly understood. Consult you dealer concerning
installation procedures.
INSTALLING A REAR CAMERA TO PARK/REVERSE SAFELY
A separate parking/reversing camera can automatically switch video to the rear camera and guide the driver.
To reverse gear control switch
WHITE
OPEN
TOP VIEW
FRONT
SIDE
LINE OUT
LINE OUT
ANTENNA
CONNECTOR
FRONT
REAR
AUDIO OUT CAMERA IN VIDEO IN
VIDEO OUT 1
VIDEO OUT 2
FUSE 10A
L
R
L
R
L
R
ISO CONNECTOR
B
A
1
2
3
4
5
6
7
8
4
5 7
8
REAR
CAMERA IN VIDEO IN
L
R
R
To rear camera video out
Steps:
1. Connect the Rear Camera IN plug to the rear camera’s
Y
ideo out plug.
2. Connect the RED wire to “REVERSE” gear control switch.
3. Check your gear control switch and make sure it is
connected to +12V.
To Hand brake switch
GREEN
OPEN
TOP VIEW
FRONT
SIDE
WHITE
Steps:
1. Connect the gray wire to the hand brake system.
2. Check your hand brake switch and make sure it is connected
to car body chassis and properly grounded.
Summary of Contents for AX1206BT
Page 16: ......