AXIOMTEK SHB130 Series, User Manual

Page: 13 / 85

SHB130 LGA1150 Full-size CPU Card
Board and Pin Assignments 7
2.3 Jumper Settings
Jumper is a small component consisting of jumper clip and jumper pins. Install jumper clip on 2
jumper pins to close. And remove jumper clip from 2 jumper pins to open. The following
illustration shows how to set up jumper.
Before applying power to SHB130 Series, please make sure all of the jumpers are in factory
default position. Below you can find a summary table and onboard default settings.
Jumper Description Setting
JP1
Audio Amplifier Selection
Default: Disable
1-3, 2-4 Close
JP2
Restore BIOS Optimal Defaults
Default: Normal Operation
1-2 Close
JP4
Auto Power On
Default: Disable
1-2 Close