AXIOMTEK MANO840, User Manual

Page: 13 / 64

MANO840 Mini ITX Motherboard
Board and Pin Assignments 7
2.3.1 Clear CMOS (CLR_CMOS)
This jumper allows you to clear the Real Time Clock (RTC) RAM in CMOS. You can
clear the CMOS memory of date, time, and system setup parameters by erasing the
CMOS RTC RAM data. The onboard button cell battery powers the RAM data in CMOS,
which includes system setup information such as system passwords.
To erase the RTC RAM:
1.
Turn OFF the computer and unplug the power cord.
2. Remove the onboard battery.
3. Move the jumper clip from pins 1-2 (default) to pins 2-3. Keep the clip on pins 2-3
for about 5~10 seconds, then move the clip back to pins 1-2.
4. Re-install the battery.
5. Plug the power cord and turn ON the computer.
6. Hold down the <Del> key during the boot process and enter BIOS setup to re-enter
data.
Caution
Except when clearing the RTC RAM, never remove the clip on this jumper
default position. Removing the clip will cause system boot failure!
Note
You do not need to clear the RTC when the system hangs due to
overclocking. For system failure due to overclocking, use the C.P.R. (CPU
Parameter Recall) feature. Shut down and reboot the system so the BIOS
can automatically reset parameter settings to default values.
2.3.2 VCON Voltage Select (VCON)
This jumper allows you to select the panel type of LVDS panel.
2.3.3 LVDS Backlight Power Select (LCD_PWR1)
This jumper allows you to select the panel power mode of LVDS panel.
Function Setting
Normal operation (Default) 1-2 close
Clear CMOS 2-3 close
Function Setting
+3.3 1-2 close
GND(Default) 2-3 close
Function Setting
+5V (Default) 1-2 close
+3.3V 2-3 close