AXIOMTEK MANO321 Series, User Manual

Page: 14 / 63

MANO321 Mini ITX Motherboard
8 Board and Pin Assignments
Note
To identify the first pin of a header or jumper, please refer to the following
information:
⚫
Usually, there is a thick line or a triangle near the header or jumper pin 1.
⚫
Square pad, which you can find on the back of the motherboard, is usually
used for pin 1.
2.3 Jumper Settings
Jumper is a small component consisting of jumper clip and jumper pins. Install jumper clip on
2 jumper pins to close. And remove jumper clip from 2 jumper pins to open. The following
illustration shows how to set up jumper.
Before applying power to MANO321 Series, please make sure all the jumpers are in factory
default position. Below you can find a summary table of all jumpers and onboard default settings.
Note
Once the default jumper setting needs to be changed, please do it under power-
off condition.