AXIOMTEK CAPA13S Series, User Manual

Page: 16 / 69

CAPA13S Capa Board
10 Board and Pin Assignments
2.4 Jumper and Switch Settings
Jumper is a small component consisting of jumper clip and jumper pins. Install jumper clip on 2
jumper pins to close. And remove jumper clip from 2 jumper pins to open. Below illustration
shows how to set up jumper.
Properly configure jumper and switch settings on the CAPA13S to meet your application
purpose. Below you can find a summary table of jumper, switch and onboard default settings.
Note
Once the default jumper or switch setting needs to be changed, please do it under
power-off condition.
Jumper and Switch Description Setting
JP1
eDP Voltage Selection
Default: +3.3V
1-2 Close
SW1
Restore BIOS Optimal Defaults
Default: Normal Operation
Release
SSW1
Auto Power On
Default: Disable
1-2 Close