D E M O 9 S 1 2 H Y 6 4
D O C - 0 4 8 0 - 0 2 0
Q U I C K S T A R T G U I D E
R E V 1 . 0 0 1 / 2 0 0 9
2
Install CodeWarrior for Microcontrollers:
Insert the CodeWarrior Development Studio for Microcontrollers CD into a CD / DVD drive. The installation pro-
gram will start automatically. If the installation fails to start, start the installation program manually. Open Win-
dows Explorer and navigate to the CD / DVD drive where the CodeWarrior disk is inserted. Double click on
Launch.exe to launch the installer. Follow the on-screen instructions to install the CodeWarrior IDE and inte-
grated programmer.
To Launch the Demo Program:
The DEMO9RS08KB12 ships with a demonstration program preloaded into on-chip FLASH memory. The dem-
onstration program converts an analog reading from the POT and the Light Sensor to control the LEDs. The in-
ternal TPM is used to flash and LED. ASCII text is echoed to the terminal.
1. Verify the option jumpers are set in default positions. Refer to Figure 1 above.
2. Connect the included A/B USB cable between an open USB port on the host PC and the USB connector on
the target board. Follow the on-screen instructions to install the necessary USB drivers.
3. Rotate the POT fully in both directions. LED1 and LED2 combine to display the POT position.
4. Press SW1. Cover and uncover the light sensor at RZ1. LED1 and LED2 combine to display ambient light
incident on the sensor.
5. Connect a serial cable to the DB9 at J4. Open a terminal program such as AxIDE, and configure for 19200,
8, N, 1. Text typed in the terminal window will echo to the screen
The Quick Start CodeWarrior Project may be downloaded from the Axiom Manufacturing web site at
Troubleshooting
If the demonstration application fails to function as indicated above, please follow the steps below before contact-
ing Freescale Semiconductors. Please refer to the TIC card included in the DEMO9RS08KB12 kit for contact in-
formation.
Ensure the option jumpers are set to default positions. Refer to Figure 1 above.
Ensure the correct version of CodeWarrior is installed and that the KB12 Service Pack is installed
Ensure D300 and VDD LED’s are both ON
If the above Troubleshooting Tips fail to correct the problem, please contact Freescale Semiconductors for further
assistance. Refer to the Technical Information Card (TIC) included in the kit for contact information. The user
may also contact Axiom Manufacturing directly at
