EDITING USER PRESETS
If you connect the CX15A to a PC, using PRONET Control So ware you can edit the user presets. In par cular, the user preset no.
4-U can be loaded also from the unit’s control panel without the need to connect again the loudspeaker to PRONET.
Here below there is a a brief explana on about how to edit the main DSP parameters.
In/Out - Level:
adjusts the input level gain in the range of -30 ÷ +6 dB (this is a digital control a er the A/D converter).
In/Out - Input Meter:
shows the input level signal a er the A/D converter. Green LED indicates the normal opera ng level before nominal input
sensi vity (+4 dBu), yellow LED indicates that the signal exceeds the nominal sensi vity, red LED indicates digital clipping and must be avoided.
In/Out - Compressor/Limiter:
this is a compressor/limiter for the input signal, that can be used to increase loudness and transparency (for the
best results, we recommend to not change the factory se ngs).
In/Out - Output Level Trim:
use these controls in you want to trim
fi
nely the level of woofer and HF driver.
In/Out - MUTE:
these bu ons can be used to switch o
ff
the woofer or the HF driver in order to check the system.
In/Out - Input Delay:
edit this box to apply a delay to the speaker, to be used pically if you need to align in me the speaker to another sound
source.
Note: a delay higher than 10 mS (3 m) is easily audible and it can be annoying to singers and musicians.
PEQ - EQ1-5:
5-band full parametric EQ.
Note: CX15A is already op
Ɵ
mized for the best performance for wedge monitoring, so we suggest to make
only small adjustments.
Setup - Device Name:
here you can assign a unique name at the unit (twelve characters are available).
Setup - Device Group:
here you assign the unit to a group, so when the LINK func on on PRONET so ware is ac vated, you can automa cally set
the same parameters to all the units assigned to the same group.
Summary of Contents for CX15A
Page 7: ......
