Axiom CNC Series, Assembly Manual

Page: 8 / 29

8
Figure 8: Castors and feet
Remove all contents from shipping boxes. Do not discard carton or packing material until
assembly is complete. Accessories commonly ship inside machine or stand packaging and
can be easily over looked.
S
TAND
A
SSEMBLY
Tools required for assembly:
#2 Philips-Screwdriver
10mm, 13mm and 17mm sockets and socket wrench
24mm open-end wrench
2mm and 3mm Allen key
Spirit Level
Assembling Stand (all models):
Assembly for stand fitting all Basic and Pro model machines is the same. The only difference
is the length of the cross braces.
1- Thread a loose hex-nut onto each of the levelling feet.
2- Turn the square stand uprights upside down. Do this on
top of the cardboard packaging to prevent scratching.
a. Install the levelling feet and swivel casters using
M6 hex bolt, M6 lock washer, and M6 flat washer
for each caster. Tighten all the caster hardware
securely. The levelling feet can be adjusted later.
b. Rotate uprights so the cross-brace mounting plates
are facing each other. Separate the uprights far
enough that the braces can fit between them.
c. Align the cross-braces between the uprights and
bolt the mounting flanges to the plates using (4) M8
hex bolt, (4) lock washers and (4) flat washers for each side. We recommend that
you do not fully tighten these bolts until the machine is securely fixed on top of the
stand as this makes the machine and stand alignment easier.
IMPORTANT NOTE : As seen in the diagram above (Figure 9), the braces should be
rotated correctly for the toolbox and shelf to sit at the correct height. Braces
should be mounted so that the top and bottom are the larger flat surfaces*
3- With assistance, the stand can now be flipped over onto the casters and levelling feet.
4- Flip the shelf upside down and stick of the rubber pads on each corner of the shelf flange.
a. Install shelf between the braces on the stand, all the way forward.
Figure 9: Bolted connections for stand