Field of application:
The devices are suited only for distributing radio and television signals in
the house! If the device is used for other purposes, no warranty is given!
RF Installation:
Connect the inline amplifier depending on type in one of the following ways
4
Between the SAT antenna and the antenna wall outlet (1, 2, and 3).
4
Between the SAT antenna and the multiswich inputs (4 and 5).
4
Between a multiswich output and the antenna wall outlet (6 and 7).
4
Use a highly shielded coaxial cable with F connectors. Suited cables
and connectors can be found in the current AXING catalogue or at
www.axing.com.
Applications with multiswitches:
4
Install four SVS 2-00 amplifiers between the LNB outputs and the
multiswitch inputs.The SVS 2-00 amplifies the SAT-IF signals (4/5).
4
Install the SVS 2-02 amplifiers between multiswitch outputs and the
antenna wall outlets. The broadband amplifier amplifies all signals. At
the outlets you can connect SAT receivers, TV and radio devices (6).
Note: Terrestrial reception only, when the SAT receiver is on.
Applications with return path:
The SVS 2-05 is suiatble for returnpath. Install the SVS 2-05 amplifiers
between multiswitch outputs and the antenna wall outlets (6).
Terrestrial reception:
The SAT amplifiers SVS 2-02 and SVS 4-00 also can amplify terrestrial
signals (e.g. FM radio). Therefor the SAT signal and the terrsrtrial signal
have to be combined with a SAT combiner like SWE 20-01.
Power supply:
The inline amplifiers have to be remote feed over the coaxil cable. They are
remote feedable at input or output.
4
Check wether your SAT receiver or multiswitch has an integrated
power supply, which can be used, to support the amplifier.
Active components, such as LNBs, which are installed after the inline
amplfier can be remote power fed with the indicated voltage of the relevant
inline amplifier.
4
Check wether the power supply can supply all active components,
check the maximum nominal current of the power supply.
4
Ckeck also the maximum DC path of the SVS amplifier.
The SAT amplifier SVS 2-04
can be directly connected to
the LNB.
Thanks of the frequency rang of
2400 MHz, the SVS amplifiers
can be used with wide band
LNBs.
j
k
l
m
n
o
p
Note: Terrestrial reception
only, when SAT receiver is on.
Important: Please make sure, that possible standards and safety regulations
regarding electrical grounding must be kept.
