Standard Operating Manual
AX030-0090-MANUAL | 6
IV. Specifications
V. Air Supply
It is important that an adequate volume of relatively clean and dry air be supplied to
the turntable. Refer to the attached detail drawing of your system for specific air
requirements and air-line size.
Part Number
Top Size
Bearing Size Estimated Air
Consumption
Capacity*
(lbs.)
Bearing
Number
BRGKD0001
N/A
37 in.
N/A
16,000 lbs.
BRGKD0001
*Capacity = Nominal rated capacity of the turntable. Actual rating may vary based on the load
configuration and duty cycle.
VI. Operation
Once you have plugged the provided power cable into the wall outlet (120V) you should
have power to the digital indicator as shown below, and your drive motor should have
power. The air-spring actuator switch will engage/disengage the drive-wheel air spring
to provide the power to keep the wheel engaged. The spring is engaged when the
switch is in the “down” position. The table can then be turned either clockwise (CW) or
counterclockwise (CCW) by the switch.
The scale and digital indicator have their own operator’s manuals that will be provided
as a supplement to this manual. It is best to center the load onto the turntable for best
results.
NOTE: DO NOT let anything overhang the turntable as this may cause damage to the
unit if it were to rotate.
Digital Indicator
Drive Forward/Reverse
Air Spring Actuator
Air Connection
Electrical Connection
