Configuring a Nanobeam as a station
1. Connect the device to the internet.
2. Open a web browser and navigate to
192.168.1.20
.
3. Click on
dismiss when asked to change the password.
4. Click on the tab
Wireless and select Station under Wireless mode.
5. Check
WDS (Transparent Bridge Mode), Frequency Scan List, MHz, and
Hide
Indoor Channels.
6. Select
Tools and Site Survey.... Active devices and frequencies (GHz) in the
nearby are will now be shown. Select a vacant range.
7. Select bandwidth under
Channel Width. Station and access point should
have the same band width.
8. Select
Frequency Scan List, MHz, click on Edit and select the desired
frequency. Station and access point should have the same frequency.
9. Select
WPA2/AES udner Security and choose a WPA Preshared Key with at
least eight characters. These settings has to be identical for the
Station and
Access Point.
10. Under the tab
Network, enter an IP address for the unit, for example,
10.0.0.82.
11. Under the tab
Wireless, enter Output Power, the value should be the same
on the station and access point and is chosen depending on the distance
between the devices. Note that the signal is cleaner when a lower power is
selected.
12. Click on
Change and then apply.
13. Disconnect the device from the network but keep it powered. The units
should not be connected to the same network.
14. After the access point has been created, click on
Select... by SSID for the
station
and lock it to the access point.
4 (7)
Manual Ubiquiti M5
