Installation
2.2.2 - Ethernet Connection
Plug the network cable into the socket labeled 'NET' on the terminal rear panel.
Note
: the terminal network operating mode is indicated by two LEDs located on
each side of the terminal network socket:
- The green LED on the left: It lights to indicate a satisfactory connection to
the Ethernet circuit (link). If the LED does not light, check that the
Ethernet connector and cable both comply with the specifications listed in
chapter 4.1.
- The orange LED on the right indicates the actual network speed: 10Mb
when the light is off and 100 Mb when the light is on.
2.2.3 - Auxiliary Ports
AX3000 Models 85 have three auxiliary ports as a standard feature:
- AUX1:
bi-directional serial port, RJ45 connector,
- AUX2:
bi-directional serial port, RJ45 connector,
- PARALLEL: parallel port, female 25-pin connector.
Cable pin assignments are listed in chapter 4.
To comply with EMC regulations, the serial cables must be shielded.
2.2.4 - USB Ports
AX3000 Model 85 has two USB ports as a standard feature. These ports are
located on the left side of the terminal case.
The USB cables must be shielded and cable length must not exceed 5 meters.
For more information (USB technical specifications, electric consumption...),
see Chapter 4.
Installation Guide - Models 85
5
