Digital door spy
DDS 2
73-002.2 (11-14)
Operation – Use of camera
Visitors / view camera image
- In the main menu, press the On/Off key to activate the
camera.
- The ring tone sounds when the door bell is pressed. The
screen turns on automatically and shows the camera image.
A photo of the camera image is also saved. The image turns
off again when the set time has lapsed.
- In the main menu, press the key to save a photo of the
camera image.
Viewing and removing photos
- In the main menu, press the key to view the photos.
- Press the or key to scroll through the photos.
- Keep the key pressed to remove the photo.
- Confirm removal of the photo with the key .
Automatic saving of photos
- Photos can be saved to the appliance
(standard) or to a TF memory card.
Memory card installation
- A TF memory card is not included. This must be purchased by
the user.
- Install the TF memory card before placing the
batteries.
- To install the TF memory card, slide the metal memory card
holder towards the "Open" symbol.
- Pop the metal memory card holder up and place the TF
memory card in the holder.
- Pop the memory card holder back and slide the holder
towards the "Closed" symbol.
- Max. 8GB TF memory cards can be used.
Higher than HSC Class 6 is recommended.
Specifications
Internal memory:
About 50 photos
Door thickness: 38-110 mm
(depending on surroundings)
Camera hole size: Ø14 -22 mm
Sensor:
0.3 Mega Pixels CMOS
LCD screen:
3.2 inch TFT
Memory card:
Micro SD (TF), max. 8GB
Resolution:
QVGA (320x240)
Power:
4x AAA batteries
Dimensions (wxhxd): 125 x 85 x 18,5 mm
Weight:
260 grams
Assembly manual
For problem-free operation of this product you must follow
the instructions below carefully.
Assembly
1
Place the batteries
4
in the door spy.
2
Replace the existing door spy or drill a hole (Ø 14 mm) at eye
level. Remove the foil from the double-sided camera tape
7
and insert the camera through the door from the outside.
Ensure that the bell head
6
points straight down (figure
A
).
Do not fold or pull on the camera connecting cable
3
Disassemble the mounting plate
5
at the bottom of the
screen
1
by unscrewing
2
the bolt(figure
B
).
4
Remove the foil of the double-sided tape on the back of the
mounting plate(figure
B
).
5
Insert the camera connecting cable
8
through the mounting
plate and stick the mounting plate with the arrow pointing
upwards, to the inside of the door. Screw the mounting sleeve
9
onto the camera thread using the mounting key
10
(figure
C
).
The arrow on the mounting plate must point upwards
6
Carefully connect the camera plug to the back of the screen.
7
Hook the screen over the top of the mounting plate and
secure the unit using the bolt (figure
D
).
8
The AXA Digital door spy is ready for use.
B
C
D
Door
A