Plug the final connector into the valve control motor
mounted on the SwitchPath™ rear section (part TX), as
shown at the arrow in
Figure 13
.
Before securing any parts of the SwitchPath™ Remote Kit,
reconnect the battery and check to make sure the system is
operating correctly.
Zip
-
tie the controller box behind the bumper support along
with the remainder of the harness into an appropriate
location.
Be sure the SwitchPath™ controller & harness will not
make contact with a hot exhaust.
The SwitchPath™ Remote can be hung on a keychain, or
located on the inside of the vehicle using the supplied
mount. Use the supplied double
-
sided tape or plastic
screws to secure the mount to the desired location within the
cabin (i.e. in the center console or glovebox).
Mount shown next to the remote in
Figure 14.
Underneath the car, locate and plug the harness male
connector, at
Arrow A
, into the SwitchPath™ controller
harness’s female connector, at
Arrow B
in
Figure 12
.
The SwitchPath™ controller harness contains a long branch
that will connect to the valve control motor on the driver side
tailpipe, route this part of the harness above the underbody
bumper panel, shown by
Arrow C
in
Figure 12.
