Award PCM-9361, User Manual

Page: 19 / 70

13 PCM-9361 User Manual
Chapter 2
H
/W installation
2.2.2 Connector Settings
2.2.2.1 Audio Interface (CN1)
Audio Port Connectors
One 5 x 2 pin box header for Audio connector. These audio connectors are used for
audio devices. The audio jacks are differentiated by color for different audio sound
effects.
2.2.2.2 USB Connectors (CN2, CN3, CN20)
The board provides up to Five USB (Universal Serial Bus) ports. This gives complete
Plug and Play, and hot attach/detach for up to 127 external devices. The USB inter-
face comply with USB specification Rev. 2.0 which supports 480 Mbps transfer rate,
and are fuse protected.
There are 5 x 2 pin 180D (M) connectors for internal use, 4 x USB ports CN2, CN3
and one external USB port CN20. You will need an adapter cable if you use a stan-
dard USB connector. On one end the adapter cable has a 5 x 2-pin connector with a
foolproof connection to prevent it from being plugged in the wrong way and on the
other end a USB connector.
* CN3 conflicts with PC/104 connector of PC/104+ module, please plug PCI-104
module only or remove PC/104 connector of PC/104+ module.
2.2.2.3 SATA Connector (CN4, CN5)
PCM-9361 supports Serial ATA via two connectors (CN4, CN5). Data transfer rates
up to 150 MB/s are possible, enabling very fast data and file transfer, and indepen-
dent DMA operation on two ports.
2.2.2.4 Power Switch Connector (CN6)
One 2 x 1 pin wafer box (CN6) for power switch.
2.2.2.5 Power Connectors (CN8)
Main power connector, +5 V, +12 V or 5 V only
PCM-9361 supports ATX and AT modes
Use ATX power cable (PN: 1700000265 ATX-20P (M)/12P (F) 10 CM) connect CN8,
it's changed from 12pin to 20pin, provides 5 V and 12 V and other PS_ON signals.
2.2.2.6 LVDS LCD Panel Connector (CN10)
The board supports 2 channel 18-bit LVDS LCD panel display. Users can connect to
a 36-bit LVDS LCD.
2.2.2.7 GPIO (General Purpose Input Output) (CN12)
The board supports 8-bit GPIO through GPIO connector. The 8 digital in and out-puts
can be programmed to read or control devices, with input or output defined. The
default setting is 4 bits input and 4 bits output.
2.2.2.8 TTL LCD Panel Connector (CN13)
The board supports 18-bit TTL LCD panel displays.
2.2.2.9 Power & HDD LED Indicator (CN15)
The HDD LED indicator for hard disk access is an active low signal (24 mA sink rate).
Power supply activity LED indicator.
2.2.2.10 SMBus Connector (CN16)
One 4 x 1 pin wafer box (CN16) supports SMBus interface.