ORCA Floor Mount Van
ity
Installation Guide
1
Rubber
Mallet
Silicone
Pencil
Screwdriver
SAFETY INFORMATION
• Read all instructions before starting installation.
•
We recommend that a qualified tradesperson install this vanity.
•
This installation is a two-person job due to the weight and size of the product.
•
Check the product immediately upon receipt for any missing packs/parts or damage during transit. If any damage
or faults are found, DO NOT install the product - contact our customer service team at Award Brands via toll-free
phone no. 1800 354 435 (outside Victoria) or (03) 9871 8444 inside Victoria. Damage reported after installation
will void the warranty of this product.
NOTE: This vanity unit is to be mounted on a secure surface. Award Brands shall not accept responsibility for any
damage caused by improper installation.
•
Depending on the installation, you may need to drill or cut out holes on the back of the vanity to suit your pipe
work, it is recommended that you should measure your pipe work and mark the measurements to the back of the
vanity first, double check to ensure the measurements and markings are correct before drilling or cutting out holes
at the back of the vanity unit.
•
Standard pop-up waste is provided with the vanity top.
•
To easily access back of cabinet when installing plumbing pipework, remove drawers as described on Page 3.
•
Due to transit, some adjustment to hardware parts maybe required to correct any gaps or alignment issues. (follow
the instructions on page 3).
• Do not stand or sit on this vanity at any time.
October 2015
TOOLS REQUIRED FOR INSTALLATION
Cloth
Drill
Measuring Tape
Methylated
Spirits
Spirit Level
SIZES 900mm & 1200mm
