Award D3602DW, Instruction Manual

Page: 20 / 26

14
Electrical Requirements
Ensure the voltage and frequency of the power being corresponds to
those on the rating plate. Only insert the plug into an electrical socket which is earthed
properly. If the electrical socket to which the appliance must be connected is not
appropriate for the plug , replace the socket, rather than using a adaptors or the like as
they could cause overheating and burns.
Electrical Connection
Insure proper ground
exists before use
Please look at the rating label to know the rating voltage and connect the dishwasher to the appropriate power supply.
Use the required fuse 10 amp, time delay fuse or circuit breaker recommended and provide separate circuit serving
only this appliance.
Positioning the Appliance
and drain hoses that can be positioned to the right or the left to facilitate proper installation.
Cold Water Connection
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure
that it is fastened tightly in place. If the water pipes are new or have not been used for
an extended period of time, let the water run to make sure that the water is clear and
free of impurities. If this precaution is not taken, there is a risk that the water inlet can
get blocked and damage the appliance.
Please note: If the supplied hose connection does not fit your tap, please contact your
local plumbingsupply center where adapters are available for purchase.
please close the hydrant after using.
WARNING!
Water Connection
About Power Connection
WARNING!
For personal safety:
Do not use an extension cord or an adapter plug
with this appliance.
Do not
under any circumstance, cut or remove the earthing connection from
the power cord.
n
n