4
2. Please follow the installation diagram when installing built-in wine cabinets. No less
than the minimum installation dimension, or it will affect the venting of cabinet.
3. Built-in wine cabinets draw air from right of ventilation frame and expel through left of
ventilation frame under the front door.
4. “Built in” wine cabinets have a power switch located on the control panel so power
point location is not critical.
5. The wine cabinet requires a standard 240 volt/10 amp power point.
6. The power cord is 2.0m in length and is fixed on the right side at the back when looking
from front of cabinet.
7. As with most appliances of today, the wine cabinet has sensitive electronic components
which are susceptible to damage through lightning and electricity supply faults. It is
therefore advised to use a power surge protector to avoid problems of this nature.
8.
Air vent on door must be provided for built-in wine cabinets when a wood door
installed.
In Hot climate zone, an air vent or grid, with a minimum ventilation size of 200mm x
40mm MUST be cut out at the rear top of the back partitioning or at the top of either side
of the partitioning, allowing cool fresh air full access to flow into the 30mm gap located at
the rear of the cabinet.
This air vent or grid must not be opened on the same side as other appliances such as
ovens or an area that is sealed and without access to fresh cool air.
Failing to comply with
the above specifications will void the WARRANTY
.
INSTALLATION DRAWINGS FOR BUILT IN WINE CABINETS:
(UNDERBENCH
OR IN COLUMN)
FRONT VENTING WINE CABINETS ONLY
.
Note:
The appliance must be positioned so that the plug is accessible after installed.
DIMENSIONAL DRAWINGS:
