②
Route the cables and connect the relevant cables. Then fasten the
mounting base to the wall with the screws and drywall anchors in
the package.
DIRECT ACCESS THROUGH WEB BROWSER
①
Make sure that the camera and the PC are connected via LAN.
②
Find the IP-Tool from the CD and then install the program onto your
computer. Run the IP-Tool program.
③
Modify the IP address and make sure its network address is in the
same local network segment as the computer’s.
④
Open your web browser and enter the modified IP address into the
address bar to login to the web client. Follow directions to download
the plugin to your computer. After that, enter the default username
and password to login.
⑥
Finish installation by fixing the cover back onto the camera firmly with the
mounting screws (make sure cover is installed on evenly).
5. NETWORK CONNECTION
①
Make sure that the camera and the PC are connected to the local network.
②
Install IP-Tool from the CD and run it after installation.
For example, if the IP address of your computer is 192.168.1.4, then you
will need to modify the IP address of the camera to 192.168.1.x. After
modifying, please enter the password of the administrator and click the
“Modify” button to modify the IP settings.
③
Modifying the IP address: The default IP address of this camera is
192.168.226.201. Click on the row of the camera listed in the above
table to show the network information on the right hand. Modify the
IP address and gateway of the camera and make sure its network
address is in the same local network segment as the recorder’s.
④
Double-click the camera listed in the IP-Tool or manually enter the IP
address in the address bar of the web browser to connect IP camera.
Then follow directions to download and install the plugin.
⑤
Enter the username and password in the login interface.
The default password of the administrator is “123456”
In LAN, there are two ways to access the camera:
③
To adjust the bracket, first preview the image of the camera on a
monitor and then loosen the lock screws with the wrench to adjust
the view angle of the camera. Then tighten the lock screws in place.
④
Open the cover of the camera as shown in the following figure and
insert a micro SD card.
*Only some models support T&W buttons. If your camera doesn't have these two buttons, please skip
step
⑤
Mounting Base
Drywall Anchors
Mounting Template
1. Access Through IP-Tool
2. Direct Access Through WEB Browser
IPC
Router
Network Cable
Network Cable
Switch
Computer
Wrench
Mounting Screws
Pan: 360°
Tilt: 90°
Rotate: 360°
Lock Screws
Micro SD Card
Cover
Zoom +
Zoom -
⑤
Press T/W button to adjust the zoom levels and obtain an optimal
image on the screen.
