INSTALLATION
Step1: Disassemble the camera case into three parts as illustrated in
Figure 1
.
Step2: Locate the base on the place you would like to install the camera; make sure the cable can be arranged
properly in the base. (Refer to Figure 2)
Figure 1
Figure 2
Step3: Drill 4 holes and screw the base to the wall (or ceiling).
Step4: Put together the bracket and the lens, and slightly adjust the camera lens. Make sure it faces your target
surveillance area.
NOTE:
Do not install the lens opposite down. (Refer to
Figure5
)
Step 5: Screw the base tight. (Refer to
Figure 6
)
Put together
Upside
Downside
Figure 3
Figure 4
Figure 5
Step 6:
Power on the camera and check the viewing angle.
Figure 6
CONNECTION
1. DC12V Input Terminal
Connect the power terminal of the camera to a DC 12V regulated power supply.
Note:
Please use the correct power adaptor, DC12V (regulated), to operate this unit. The power tolerance of
this unit is DC12V ± 10%. Over maximum DC 12V power input will damage this unit.
2. Video Output Connector (VIDEO OUT)
Connect the camera video output to the video input of a DVR with 75
Ω
coaxial cable.
Note:
To ensure the camera has sufficient protection against moisture, an extra waterproof measure, such
as by using an insulating tape, must be used to cover the power and video connectors after
connection.
