m3432_3445_2432_2421_2220_quick_V1.3
CABLE OVERVIEW
DEFAULT VALUES
Cable
Description
Power cable
DC12V power supply.
RJ45 network cable* Connect it to a RJ45 cable.
GND
Used with external alarm device connection or hardware reset.
Alarm-in**
Alarm-out**
Reserved for external alarm device connection.
RESET
Reserved for hardware reset.
Remove the insulating coating of the wire, and twist it with the GND wire
together to reset the camera to ifs factory values.
Line-in**
Colored as blue, used to connect to a microphone for audio input.
Line-out**
Colored as green, used to connect to a speaker for audio output.
* For PoE (IEEE802.3af) installation, make sure your network cable has the maximum cable resistance of 20
Ω
, such
as CAT.5e or CAT.6 cables, to conform to the standard of IEEE802.3af.
** Optional
IP address
192.168.1.10
Port number
88
User name
admin
Password admin
It's strongly recommended to change the default user name and password before using the camera to
keep your account safe.
To change the default account, log into the camera, and go to
Config.
General
Account
. Create
a new account, and remove the default one.
SYSTEM CONNECTION
1. Connect IP cameras and a monitor to the NVR, and power on the NVR, as illustrated below.
Note:
Local connection only allows monitoring locally. To monitor from anywhere other than the NVR is installed,
please connect your NVR to Internet.
2. Wait till each camera is configured automatically and you will see camera images on the monitor
soon.
Note:
Local connection only allows monitoring locally. To monitor from anywhere other than the NVR is installed,
please connect your NVR to Internet.
Type1
Type2
