this dial can be used to enable/disable this feature.
6. OUT A Connector
. This BNC connector provides the main output of the Channel A
amplifier. The output is an amplified version of the input on (3). The gain (V
OUT
/V
IN
) is
controlled by (4).
Caution: Voltages as high as ±200V may be present on the center conductor of
this output connector. Avoid touching this conductor. Connect to this connector
using standard coaxial cable, to ensure that the center conductor is not exposed.
7. IN B Connector
. The input signal for the Channel B amplifier is applied to this BNC
connector. The input must not exceed ±2V. The input impedance is approximately 1
kΩ. Depending on the length of cable attached to this input, and the source driving
it, it may be desirable to add a coaxial 50 Ohm terminator to this input to provide a
proper transmission line termination. The Pasternack (www.pasternack.com)
PE6008-50 BNC feed-thru 50 Ohm terminator is suggested for this purpose.
8. GAIN B Dial
. This ten-turn dial is used to vary the gain of the Channel B amplifier
between < 1 and > 100.
9. OFFSET B Dial
. (Optional. Requires -OS option.) This ten-turn dial is used to vary
the DC offset of the OUT B output, in the range of -50V to +50V. The switch below
this dial can be used to enable/disable this feature.
10.OUT B Connector
. This BNC connector provides the main output of the Channel B
amplifier. The output is an amplified version of the input on (7). The gain (V
OUT
/V
IN
) is
controlled by (8).
Caution: Voltages as high as ±200V may be present on the center conductor of
this output connector. Avoid touching this conductor. Connect to this connector
using standard coaxial cable, to ensure that the center conductor is not exposed.
15
V
OUT
= V
IN
× GAIN,
GAIN = +1 TO +100,
ADJUSTABLE.
± 200V MAXIMUM.
Summary of Contents for AV-110B-PS-D
Page 29: ...PERFORMANCE CHECK SHEET 29...