AVTECH ELECTROSYSTEMS AVR-2B-B, Instructions Manual

Page: 5 / 40

INTRODUCTION
The AVR-2B-B is a high performance, GPIB and RS232-equipped instrument capable
of generating 5 to 100V at repetition rates up to 100 kHz into loads of 50Ω or higher.
The pulse width is variable from 100 ns to 100 us, and the duty cycle may be as high as
50%. The maximum average output power is 100 Watts. Rise and fall times are fixed at
less than 10 ns.
The AVR-2B-B includes an internal trigger source, but it can also be triggered or gated
by an external source. A front-panel pushbutton can also be used to trigger the
instrument. The output pulse width can be set to follow an input trigger pulse width.
The output voltage polarity depends on the model number:
"-P" units: +5 to +100 Volts
"-N" units: -5 to -100 Volts
"-PN" units: ±5 to ±100 Volts
The AVR-2B-B features front panel keyboard and adjust knob control of the output
pulse parameters along with a four line by 40-character backlit LCD display of the
output amplitude, pulse width, pulse repetition frequency, and delay. The instrument
includes memory to store up to four complete instrument setups. The operator may use
the front panel or the computer interface to store a complete “snapshot” of all key
instrument settings, and recall this setup at a later time.
The instrument is protected against overload conditions (such as short circuits) by an
automatic control circuit. An internal power supply monitor removes the power to the
output stage for five seconds if an average power overload exists. After that time, the
unit operates normally for one second, and if the overload condition persists, the power
is cut again. This cycle repeats until the overload is removed.
This instrument is intended for use in research, development, test and calibration
laboratories by qualified personnel.
5