178.812UK User Manual
To listen to FM radio, press the MODE button repeatedly until the display shows
“
RADIO
”
and then the FM frequency.
There are 3 bands of FM memories
–
FM1, FM2, FM3, which can be selected in turn by a short press of the
button.
Tune in available stations by holding the
button for 3 seconds and releasing.
Once fully scanned, the stored stations can be accessed via the
and
buttons.
To connect a smart phone or other Bluetooth device to the DELTA-200 media player, press the MODE button repeatedly
until the display shows
“
BT
”
then
“
PHONE
”
. O
pen the Bluetooth menu on your device and search for “PA SYSTEM
TSR12
”.
Pair with this ID and connect in order to be able to play audio from the Bluetooth device to the DELTA-200.
During Bluetooth playback, pressing the
and
buttons will navigate tracks in the folder on the sending device.
Pressing the
will pause or play the current track.
The EQ button can also apply the POP, ROCK or CLASSIC tonal profile or select
“
EQ OFF
”
for the unaffected option.
To play audio from the 3.5mm AUX IN jack, press the MODE button repeatedly until the display shows
“
AUX IN
”
It is recommended to turn down all volume controls before powering down to avoid loud pops through the speaker.
Audio Recorder
To record the full mix of inputs that can be heard through the DELTA-200 speaker, insert a separate FAT32 formatted
USB pen drive into the USB REC port (5) and the recording LED will light to show that it is ready to record.
Press the
“
REC
”
button to start recording and the recording LED will flash whilst audio is recorded to the pen drive in
standard .wav audio format. Press the
“
REC button again to stop recording and the recorded track will be stored as a
.wav audio file named by numerical order (e.g. 001.wav)
Remote Control
In addition to the panel controls, an infra-red remote control is provided for the USB/SD player which adds some further
functions to allow greater control over the media player.
To operate, remove the clear plastic tab from the remote to activate the battery.
Charging the internal battery
When not in use but connected to the mains, if the POWER switch is in the
off
position, the internal battery
will be re-charged from the mains supply. This can be observed by the green battery status LEDs being lit.
Note:
it is recommended to store the PA unit at an ambient temperature and not with the battery fully
discharged.
1
Media player MODE select
2
Power On / Standby
3
Previous track or FM channel
4
FM tuner band (FM1, FM2, FM3)
5
Decrease volume
6
*not used*
7
Select track by number (first digit - second digit - third digit)
8
Direct access track number keys
9
Mute / Unmute
10
Play / Pause
11
Next track or FM channel
12
Repeat mode (RPT ONE, RPT ALL)
13
Increase volume
14
Select media USB or SD card
15
Enter track selection
