153.737UK User Manual
Remote control
1.
POWER
LED tape on / standby button
2.
increases brightness
3.
C/T-
decreases colour temperature
4.
C/T+
increases colour temperature
5.
BRIGHT-
decreases brightness
6.
10%
Shortcut button - 10% brightness
7.
50%
Shortcut button - 50% brightness
8.
100%
Shortcut button - 100% brightness
9.
Warm
Shortcut button - warm white colour
10.
Neutral
Shortcut button - neutral white colour
11.
Cold
Shortcut button - cold white colour
Remove the clear tab from the handheld remote to engage the battery (replacement CR2025 button cell)
To switch LEDs on, press the POWER button (from standby, the last setting is resumed)
If there is no response to the controller from the handset (it may be necessary to pair them, see “
Pairing
” below)
and BRIGHT- buttons will increase or decrease the overall brightness of the LED tape output.
C/T+ and C/T- will adjust the balance between cool white and warm white output to give different colour temperatures.
10%, 50% and 100% give quick access to the preset brightness levels.
Warm, Neutral and Cold give quick access to the 3 main colour temperature settings
Press POWER to enter standby mode (all LEDs off)
Pairing:
If the LED controller does not respond to the RF remote handset, disconnect DC power from the controller.
Reconnect the DC power to the controller and within 5 seconds of powering on, hold down the “C/T+” and “C/T-” buttons
simultaneously. The LED on the controller will flash 3 times to show that it is paired.
Further handsets can be paired to the same controller (up to 5 per controller)
Specifications
Power supply
5-24Vdc, 14A (to supply 2 x 7A max)
Remote control frequency
433.92MHz
PWM frequency
1kHz
Lead length (power input)
100mm
Remote control range
15m (max.)
Brightness settings
7 levels
Colour temperature settings
7 levels
Pairing
Up to 5 handsets per controller
Connections
DC jack and 4-pin socket (Warm+ / Warm- / Cool+ / Cool-)
Protection
Reverse/short circuit, overload, temperature
Operating temperature
-30 to +80°C
IP rating
IP63
Controller dimensions
87 x 21 x 9mm
Remote dimensions
40 x 86 x 7mm
Total weight
36g
Disposal:
The “Crossed Wheelie Bin” symbol on the product means that the product is classed as Electrical or
Electronic equipment and should not be disposed with other household or commercial waste at the end of its useful life.
The goods must be disposed of according to your local council guidelines.
Errors and omissions excepted.
Copyright© 201
7
. AVSL Group Ltd.
