RFCW2
IN-LINE WIRELESS CONTROLLER
FOR WARM/COOL WHITE LED TAPE
Item ref: 156.737UK
User Manual
WARNING
: This product is intended for professional installation of dual colour LED tape and should be
connected by qualified personnel in accordance with electrical safety standards. Ensure that the rated load
indicated is not exceeded.
Installation
The RFCW2 controller can be employed to control
Lyyt
dual colour LED tape operating from a 5-24Vdc
power supply. The rated current load is 2 x 7A, operating up to 17.5m (3 x 5m reels max. recommended)
of
Lyyt
12V high output warm/cool white LED tape (156.719UK).
Connect the DC jack to a power supply suitable for the LED tape (must be 5-24Vdc for the controller)
Connect the 4-pin coupler to the end connection on the
Lyyt
2-colour tape.
Ensure that the positive and negative connections for Warm and Cool white are connected to the correct
polarity on the LED tape. Black and yellow output leads should be connected to the side of the tape with
warm white LEDs (deep yellow in colour) and black and white output leads should be connected to the
side of the tape with cool white LEDs (pale yellow in colour). The LED tape will not light if the controller is
accidentally connected in reverse)
On the rear of the controller is an LED indicator which shows the control status, which flashes red for
overload or yellow for overheating protection. In normal use, the indicator will make a single short flash to
show control changes or a long flash to show control limits.
