DIY-3X300-RGB/DIY-3X600-RGB
LED TAPE DECOR KITS - RGB
Item ref: 156.789UK, 156.799UK
User Manual
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
LED Tape D
é
cor Kit RGB
Thank you very much for purchasing the Fluxia LED Decor kit. It includes corner joint pieces which make it ideal for installation of back
lit illumination for pictures, paintings and mirror frames.
Before starting please ensure that you have read this instruction leaflet carefully.
If you are unsure about anything please have this installed by a competent installer.
Contents:
-
4 x LED strip
-
2 x Corner strip
-
3 x snap on coupler
-
4 x pin connector
-
1 x Control Box
-
1 x Remote controller
-
PSU with UK/EU/US adapter and inline switch
Possible Required tools: Scissors, Craft knife.
Step 1: Preparation
Ensure that the surface you are attaching to is clear of dust and dirt. Clean thoroughly and leave to dry before fitting the tape.
Check individual parts are functioning correctly by connecting individual strips and corner pieces to the power supply and control box
as shown below, check all LEDs are working and colour consistency before cutting/installing. If any faults are present, return the
product to your supplier without delay.
Step 2: Cutting/Jointing
Each Fluxia D
é
cor kit is supplied with 4 x 30cm or 4 x 60cm strips which can be cut or joined to fit different sizes of frames. All strips
are marked clearly with cutting marks at 10cm intervals. Also for purpose of easy jointing, this kit is supplied with 3 snap on couplers.
Measure out each side of the frame and work out the required length for each side to decide if cutting or joining is required, please
remember to take in account the corner pieces when measuring between the two corners.
WARNING: Disconnect from the power supply before attempting any cutting.
Cutting
–
use a knife or sharp scissors to cut the strip to the required length by the closest cutting mark. Please note ALWAYS cut on
cutting mark ONLY, do NOT cut outside the cutting mark as it may cause malfunction in some of the LEDs.
