SA-series User Manual
Front panel
Bottom panel
Connections
Connect the bottom panel IEC inlet (30) to the mains using the supplied mains
lead (or an equivalent approved type). Ensure that the mains voltage is correct
(230Vac) and the mains outlet is switched on.
Mains and speaker output connections are fed through the bottom of the
cabinet and the wires can be bundled together and fed through a security
plate (supplied) to deter tampering with the connections. (see the following page for speaker connection)
If an FM aerial is to be connected (25), this can also be fed through the security plate.
Each SA-series amplifier has a total of 5 input channels. INPUT 1 and INPUT 2 are connected by either XLR or
6.3mm jack to the combo connectors on the front panel (9). It is important to determine which type of input
source is connected and make the appropriate selection on the input type selector switch (8). If the input is a
low impedance microphone, sw
itch to “MIC”.
The central input channel is for the supplied UHF wireless mic.
Aux 1 input can accept a line level signal, connected via L+R RCA connectors (12), or can alternatively be
switched over to the internal media player via the
“
AUX 1/Media
”
button (11).
Aux 2 input can also accept a line level signal, connected via L+R RCA connectors or a 3.5mm stereo jack
(which defeats the RCA connectors when connected)
1. Media player display
2. Media player controls
3. SD card slot
4. USB pen drive port
5. Input 1 + 2 Volume control
6. Input 1 + 2 Treble control
7. Input 1 + 2 Bass control
8. Input 1 + 2 Mic/Line level selector
9. Input 1 + 2 XLR/jack input
10. Priority & Phantom Power DIP switches
11. Aux 1 / Media source selector
12. Aux 1 RCA L+R input
13. Aux 2 RCA L+R input
14. Aux 2 stereo 3.5mm input (defeats RCA)
15. UHF microphone antenna BNC connector
16. UHF microphone Volume control
17. UHF microphone Treble control
18. UHF microphone Bass control
19. Aux 1/ Media & Aux 2 Volume control
20. Master Volume control
21. Aux 1/ Media & Aux 2 Treble control
22. Aux 1/ Media & Aux 2 Bass control
23. Power and VU indicator LEDs
24. Line output XLR
25. FM radio antenna F-type connector
26. 8
Ω speaker terminal
27. COM speaker terminals
28. 100V speaker terminal
29. Power on/off switch
30. IEC mains inlet & fuse holder
