AVS Uriel Systems SCOPE212WIR3, User Manual

Page: 24 / 59

24
(8) Remove LAN Cable(cross cable) connected between the camera and PC.
(9) Connect the camera to network with LAN cable(Direct cable).
(10) Connect PC to network with LAN cable(Direct cable).
(11) Set up IP address, Subnet Mask and Gate way of PC according to network environment
(Recommended to user to remember the value before changing user's PC setting).
(12) Check
Run web browser on PC, input IP address set in the unit onto URL and click as [Pic. 3-7].
When main page appears as [Pic. 3-1], click Viewer button to connect to web viewer and check if IP
setting is correct or not.
(Refer to 'Chapter 2. Installation and video check')
In case video is not seen, check whether there may be confliction of IP in network, and recheck the set
value of network environment of the camera, and network environment of User's PC.
[Pic. 3-7] Connect to the unit
[Reference] If you register on DDNS server we operate, you can use the registered
domain name for connection.
3.2.2 Dynamic IP Setup
Do not set up dynamic IP in the unit except directly connecting the camera to network supporting dynamic
IP. If the IP has not been allocated to the unit in dynamic IP setting, please press the 'FACTORY RESET
BUTTON' for 3 sec, then try to setup again.
(1) Connect the unit and PC with LAN cable(cross cable).
(2) Cable connection and network setting should be done same as
'Chapter 2. Installation and video check' and check video.
(3) Go to network setting page of administrator's page as per (3),(4),(5) of 'Static IP Setup'
If you will not connect provided internet line from ISP(Internet service provider) to unit via router and you
will connect to unit directly, we recommend to you to keep the MAC address on the network setting
page. It needs to when register to DDNS server.