- 5 -
IST1073V1.0
Acquisition and programming
•
The wireless detectors acquisition, video and not video, must be performed directly in the control panel using the keypad, following the normal
procedure described in the control panel manual.
•
Programming can be done either via keypad or using a dedicated software.
•
In programming, in the “
Satellites
” menù, number 1 must be programmed to “
YES
” and “
Satellite Type”
must be set
RVS.
•
If C8 satellite was also installed, it must be set with address n°2.
Note
: it is not possible to add XSAT WS4 VIDEO satellite
•
For each wireless video detector, the menu repeater must be set as
NONE
•
For radio video detectors there are two additional programming:
•
Request Image:
setting “YES” it configures the detector to be ready for an image requested from user by the app. MY AVS ALARM. In this
operating mode, the battery life is halved.
• Enable audio:
setting “YES” the sent videos will be with audio. This option also increases the power consumption because it lengthens the
video transfer time.
Description of RED LED operation
Flashing
:
•
RVS is receiving a frame of a video detector. The frames sequence, in a movie, consists of 10 frames and, optionally, an audio file. During the
transfer of a movie, the red LED flashes briefly for each frame or audio file received and a red double flash at the end of the sequence.
•
When you send a
request for a video
to a detector, the RED LED starts to flash more and more closely. During the
frame reception
from a
video detector, the LED flashes with a cadence of 1 or 2 seconds
Information in accordance with Directive 2014/53/UE
The product covered by this declaration complies with the essential requirements of Directive 2014/53/UE on the equipment and use low power
radio transmitters frequency spectrum, in accordance with the CEPT 70-03 Recommendation.
Declaration of conformity
AVS Electronics S.p.A. declares that
RVS
complies with the European Standard EN50131. EN50131.
The declaration of conformity may be consulted using link:
http://www.avselectronics.com/en/download-software-and-technical-manual
or by using this
QR CODE
Brand
AVS ELECTRONICS
Model
RVS
Operating frequency
868 MHz
Type of power
Direct Current
Rated voltage
13,8 V =
Rated Current
10 mA at rest
15 mA Receiving
30 mA Transmission
European Community countries where it is intended for use
No restrictions in the EU countries
Date
18/01/2021
L’
AVS ELECTRONICS S.p.a
. reserves the right to make changes at any time without advance notice.
RVS
CONNECTOR
ANTENNA
