Troubleshooting
•Verify Power - When power is applied all lights on the top of the
device will flash. You can also pressany of the 3 buttons on the
side to change settings, the corresponding lights should change
if the unitis powered up.
•Verify Connections - Make sure all connected cables are prop-
erly connected. You can use the built in Test Pattern Generator to
verify signal path from SC2 to the display
Have a question or need assistance?
Don’t hesitate to contact us!
SUPPORT: +1 605-274-6055
USA TOLL FREE: 877-886-5112
EMAIL: [email protected]
