www.avpsynth.com
To use
COSMWAVE FX
in
INDIVIDUAL
mode, each of the effects need to be
connected in a standard way - the inputs and outputs in each section are connected
respectively to the signal source and mixer or amplifying device. The
FX MODE
switch must be set in the
INDIVIDUAL
position in order for the sections to work
separately from each other.
②
PHASER
section.
Fully analog effect, therefore it has a permissible level of analog noise at the output.
Note: the noise level depends on the position of the adjustment controls.
The phaser consists of 8 stages and a low-frequency oscillator, which modulates all 8
stages by a triangular waveform (instead of LFO, you can use the
MANUAL
knob to
modulate the stages manually).
Phaser section has 5 controls:
INPUT
- sets the input signal level;
MANUAL
- allows you to manually adjust the tone (stages) of the effect;
RESONANCE
- adjusts the saturation of the effect;
DEPTH
- adjusts the depth of the phaser modulation;
RATE
- adjusts the frequency of the phaser modulation.
There is a
toggle switch
to turn the unit on/off (bypass)
③
DELAY
section.
A hybrid effect with the path of the direct signal being analog while the delay line is a
digital microprocessor. The delay time can be adjusted from 0 to 2 sec with a
feedback time of over 1 minute.
Delay section has 4 regulators:
INPUT
- sets the input signal level;
MIX
- amount of effect applied to the direct signal;
FEEDBACK
- adjusts the number of times a delayed signal is repeated;
DELAY TIME
- adjusts the delay time of the signal.