Avocent AV Works, Installer/User Manual

Page: 132 / 144

120 AVWorks Installer/User Guide
Appendix D: Ports Used by AVWorks Software
Table D.1 lists the port numbers that AVWorks software uses to communicate with certain
appliances. This information may be used to configure firewalls to allow AVWorks software to
operate in your networks.
Table D.1: Ports Used by AVWorks Software
Port Number
Appliance
1 Type Purpose
3211 A and C TCP Proprietary management protocol
3211 A and C UDP Proprietary install and discovery protocol
2068 A TCP Encrypted keyboard and mouse data
8192 A TCP Digitized video data
22 C TCP SSH connections and tunnels to serial port
23 C TCP Telnet to the CCM appliance
3001-30xx
2 C TCP Telnet to the corresponding CCM port
3100-31xx 3 C TCP Direct SSH Telnet to corresponding CCM port
1
A indicates the AutoView 1000R/2000R switch, C indicates the CCM appliance.
2
By default, port numbers that are 3000 plus the port number (for example, 3001-3008 for an 8-port CCM
appliance, 3001-3048 for a 48-port CCM appliance) are used for Telnet sessions to the devices connected
to the corresponding ports. These Telnet port numbers may be changed through the CCM AMP, and the
Serial Console Viewer will connect to the configured Telnet port number. If you change the default Telnet
port number, Avocent is not responsible for any firewall issues that may develop.
3
If the Telnet port is changed through the CCM AMP, the corresponding SSH port will be n+100.