Avocent AV Works, Installer/User Manual

Page: 120 / 144

108 AVWorks Installer/User Guide
Table C.4 lists the VT100 ANSI mode and cursor keys for set and reset modes. Encoding and
decoding is supported for all the cursor keys listed.
Table C.5 lists the VT100
PF1
through
PF4
key definitions. Encoding of each listed key is
supported; decoding is not applicable.
Table C.6 lists the ANSI mode control sequences for VT100 terminal emulation and indicates
Avocent encoding/decoding support, where Yes indicates supported and No indicates not supported.
Table C.4: VT100 ANSI Set and Reset Mode Cursor Keys
Cursor Key Mode Reset Mode Set
Up Esc [ A Esc O A
Down Esc [ B Esc O B
Right Esc [ C Esc O C
Left Esc [ D Esc O D
Table C.5: VT100 PF1 through PF4 Key Definitions
Key Code Sequence
F1 Esc [ O P
F2 Esc [ O Q
F3 Esc [ O R
F4 Esc [ O S
Table C.6: VT100 ANSI Mode Control Sequences
Control Sequence Definition Encode/Decode
Esc [ Pn; Pn R Cursor Position Report No/No
Esc [ Pn D Cursor Backward No/Yes
Esc [ Pn B Cursor Down No/Yes
Esc [ Pn C Cursor Forward No/Yes
Esc [ Pn; Pn H Cursor Position No/Yes
Esc [ Pn A Cursor Up No/Yes
Esc [ Pn c Device Attributes No/No
Esc # 8 Screen Alignment Display No/Yes