RFSoC Development Kit Getting Started Guide
Page 9
Booting ZCU111
1. Turn the ZCU111 power switch ON (near the 12V connector)
From your PC launch a terminal program with 115200/8/n/1/n settings. For the example output shown
here, Tera Term was used. For information on setting up Tera Term to use with the ZCU111 USB-
UART port, see Appendix A:
Installation of USB UART Driver
later in this document.
2. You should observe terminal output from U-Boot and then Linux output appear in the Tera Term
window. After the final boot message ‘
Server Init Done’
, press enter to generate a carriage
return and command-line prompt from ZCU111.
