AVM OVATION MP 6.2, Operating Instructions Manual

Page: 24 / 32

24
Change language
Choose one of the currently available languages of your RC 9 remote control: English,
German, French, Italian, Spanish, Dutch. The RC 9 remote control will automatically change
its language once selected.
Rename device
The menu item Rename Device provides the option to rename a paired device by using the
alphanumeric input and navigation keys (25) (11). Please note that the renaming applies only
locallly on the RC 9 remote control. If you happen to use the RC S App to control your AVM
components as well, the respective name of the device may be changed again.
Delete Device
The menu item Delete Device contains a list of all formerly paired devices. When chosen a
device, this is deleted along with all known information. In order to add a deleted device
again, please refer to section 4.7.5.
Add Zone
The menu item Add Zone provides you with an option to create a new zone with an individual
name. In order to assign a device to a certain zone, please return to System-Settings/User-
Settings and chose the menu item
HKEY Configuration (see above).
Rename Zone
The menu item Rename Zone lists all known zones and provides the possibility to rename
them (living room, kitchen, etc.) by using the alphanumeric input and navigation keys (25) (11).
Delete Zone
The menu item Delete Zone provides a list of all existing zones and the possibility to delete
these along with all known data.
Transportation lock
The transportation lock deactivates the motion sensor and secures the RC 9 remote control
against unintentional power-up and thus saves battery while moving. In order to activate the
transportation lock please navigate to the menu item
Transportation lock
and press the
Enter key (10). In order to deactivate the transportation lock again, please press any key on
your RC 9 remote control.
4.7.5 Pairing
In order to control a MP 6.2 with your RC 9 remote control, both devices need to be linked
first. This process is also referred to as
Pairing . in order to start the pairing process, please
switch off your MP 6.2 by using the mains switch (35) on the rear side of the unit. Now please
navigate to the
Systems Settings menu on your RC 9 remote control by pressing the
Settings key (9) and navigate to the menu item
Start Pairing without
selecting it with the
Enter key yet. Switch on your MP 6.2 by using the mains switch on the rear side of the unit
(35) and immediately press the Enter key of your RC 9 remote control (10). The name of a
succesfully detected device (such as your MP 6.2) will instantaneously be shown on the
display of your RC 9 remote control and can be edited by using the alphanumeric input keys