Latest products and information available at www.avlite.com
10
Universal DC Low Intensity Obstruction Light
Single Light Fixture
Unpack all hardware and inspect for damage. If there is any damage, please contact your Avlite Office.
Retain original packing material for possible future use in shipping.
Unpacking, Installation, Wiring & Setup
Unpacking
Installation & Wiring
Before proceding with installation or service, make sure the following conditions are met:
• Ensure the tower or mast is grounded (NO RF HAZARD)
• Check the mast lighting circuit is not faulty
• Ensure power lines are not ‘live’ (NO ELECTRICAL HAZARD)
• Avoid touching live circuits!
• Avoid touching any component or any part of the circuitry while the unit is operating. Do not change
components or make adjustments inside the unit with power on.
Open the Obstruction Light as described. Guide the cable through the cable gland and mount the
bottom half of the Obstruction Light on a mounting pole using the inner thread.
NOTE:
• Make sure the mounting pole is vertically aligned to guarantee the required beam pattern of the
obstruction light
• Make sure the light’s beam pattern is not disturbed by any nearby obstacles
Shorten the cable and close/seal the cable gland.
With the unit open, observe the rear of the PCB mounted in the top half of the Obstruction Light for
terminal blocks and switch settings.
NOTE:
Use cable in compliance with the effective local electrical code. The cable outer diameter
should be between 5mm and 10mm.
NOTE:
There is no requirement to terminate the relay and/or the serial communication if not used.
