* Please refer the table on Page.5 for all AViPAS cameras port information.
•
KEYBOARD:
a.
Set up controller IP:
Press
【
SETUP
】
-
> push the joystick down to select the submenu, until “
Setup 05/08
” shows on the
screen for
Mode
selection;
Push the joystick
rightward to choose the protocol: “
ONVIF
”
-> press the button on the joystick to enter,
or press
【
ENTER
】
;
Press
【
SETUP
】
again -
> push the joystick down to select the submenu, until “
Setup 02/10
” shows on
the screen for
IP
selection-> push the joystick to the r
ight until it shows “
IP: Static
”
-> press
【
ENTER
】
;
Use the keyboard to set the IP address of the controller: (Connected with AV-1280 series)
192.168.5.100
-> press
【
ENTER
】
to go to the next section;
* Keep the first 3 sections (192.168.5) the same as the connected camera, while the last section different. In this
case, camera: 192.168.5.163; controller: 192.168.5.100.
*If there’re less than 3 digits in the section, push the joystick to the right to go to the next section.
Subnet mask: keep the same as the connected camera.
255.255.255.0
-> press
【
ENTER
】
to go to the
next section;
Gateway: keep the same as the connected camera.
192.168.5.1
-> press
【
ENTER
】
The controller will reboot. You should be able to see “
192.168.5.100 ONVIF
” on the screen when the
controller finishes rebooting. It's the controller’s IP information.
b.
Set up camera connection
Press
【
IP
】
-> enter the IP address of the controlled camera:
192.168.5.163
-> press
【
ENTER
】
to go to
the next section;
Port (ONVIF):
2000
-> press
【
ENTER
】
to go to the next section;
User Name:
admin
-> press
【
ENTER
】
to go to the next section;
Password:
admin
-> press
【
ENTER
】
to go to the next section;
Cam Num: choose any number from 1-255. This Cam Num will be assigned to the current camera.
