How to connect PTZ camera with AV-3104IP
Please make sure that the camera and the keyboard are both powered, and they are connected with
either a RS-232 (IN), RS422 or an Ethernet cable.
1.
IP VISCA (via Ethernet port)
To properly set up the connection, you need to make sure that the camera supports IP VISCA and the
keyboard is within the same LAN as the camera.
•
CAMERA:
Before setting up the connection on the keyboard, you’ll need to get some information of your camera:
Camera IP Address
: take AV-1080 series (AV-1080/1081/1082/1280/1281/1562/1563) as an example,
its IP address is 192.168.5.163.
Subnet mask:
255.255.255.0
Gateway:
192.168.5.1
UDP Port:
1259
*Please refer the table on Page.5 for all AViPAS cameras port information.
•
KEYBOARD:
a.
Set up controller IP:
Press
【
SETUP
】
-
> push the joystick down to select the submenu, until “
Setup 05/08
” shows on the
screen for
Mode
selection;
Push the joystick rightward to choose the protocol: “
IP VISCA
”
-> press the button on the joystick to
enter, or press
【
ENTER
】
;
Press
【
SETUP
】
again -
> push the joystick down to select the submenu, until “
Setup 02/10
” shows on
the screen for
IP
selection-
> push the joystick to the right until it shows “
IP: Static
”
-> press
【
ENTER
】
;
Use the keyboard to set the IP address of the controller: (Connected with AV-1080 series)
192.168.5.100
-> press
【
ENTER
】
to go to the next section;
* Keep the first 3 sections (192.168.5) the same as the connected camera, while the last section different. In this
case, camera: 192.168.5.163; controller: 192.168.5.100.
