Charging the device
1.
Remove the charging adaptor cover at the bottom of the unit (see figure 1)
2.
Plug the included adaptor into the unit and secure the cover (see figure 2)
3.
Fix the adaptor jack firmly into the charging base (see figure 3)
4.
Plug the adaptor into a wall plug and place the device on the charging stand (see figure 4)
5.
The charging indicator on the product will flash blue when it is charging and will turn to a sold
blue light when it is fully charged.
Note:
The device must
not
be used whilst connected to the charger
Operating Instructions
1.
Select the preferred interchangeable head and screw the attachment
(clockwise) securely into the head of the massage gun.
Note:
The cold gel attachment needs to be placed in the freezer for 1 to 2 hours
before use
2.
Press and hold the on button on the shaft of the device for 3 seconds to power up the product.
Once on, the red and blue indicator lights will turn on and the massage gun will start at the
lowest level ‘LO’.
3.
The product is ready for use – simply apply the desired pressure to the desired part of the body
as needed. We recommend always starting at the lowest pressure and increasing the intensity
or pressure as required.
4.
To increase the intensity setting, simply press the power button to increase from ‘LO’ level to
the ‘MID’ level and press again to turn up to ‘HI’ level (the highest of the 3 levels).
5.
5. To turn off the product, simply press and hold the power button for 3 seconds until product
stops.
Note: The product has a blocking protection that will automatically stop the device is there is too
much pressure on the massage head. This is to stop the internal electronic components from
burning. Simply reduce pressure and press start button to re-start the device.
User Notes
1.
Use the silicone strap to assist you with your grip and angle whilst in use
2.
The massager has a built into auto off function preset to 10 minutes
3.
Once the power or intensity of the product start to lessen or slow down, this indicates the
product should be placed onto the stand to re-charge
Maintenance
1.
To clean and maintain the product, use a damp cloth to clean the device and dry completely
before use.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
