NOTE:
The default camera username is
admin
and the default password is
admin
.
Accessing the Live Video Stream
Live video stream can be viewed using one of the following methods:
l
Web browser interface: http://
<IP address>
/
l
Network video management software application (for example, the Avigilon Control Center software).
NOTE:
The default camera username is
admin
and the default camera password is
admin
.
Aiming the Dome Camera
1. Loosen the pan and tilt lock screws on the camera.
2. Turn the lens to the desired direction by panning and tilting the lens.
3. Once satisfied, tighten the pan and tilt lock screws to secure the dome camera’s position.
4. Rotate the azimuth control ring to set the image to the correct angle.
5. In the Camera Installation Tool or camera web browser interface, adjust the camera’s Image and Display
settings. From either applications, you can set the desired zoom position, and change the image rotation.
(Optional) Configuring SD Card Storage
NOTE:
Only available on models that feature an SD card slot.
To use the camera's SD card storage feature, you must insert an SD card into the card slot.
It is recommended that the SD card have a capacity of 8 GB or more and a write speed of class 6 or better. If the
SD card does not meet the recommended capacity or write speed, the recording performance may suffer and
result in the loss of frames or footage.
1. Insert an SD card into the camera.
CAUTION —
Do not force the SD card into the camera or you may damage the card and the
camera. The SD card can only be inserted in the orientation shown on the camera.
2. Access the camera’s web interface to enable the onboard storage feature. For more information, see the
Avigilon High Definition H.264 Camera Web Interface User Guide
.
Installing the Dome Cover
1. Rotate the black shield located inside the dome bubble so that it does not block the camera’s field of
view.
Skip this step if you are installing a dome camera with IR illumination.
2. Attach the dome cover to the base by tightening the screws with the provided Torx key.
3. Be especially careful not to mark the dome bubble or the contaminants will cause unwanted reflections in
the -IR model.
4. Remove the plastic cover on the dome bubble.
Accessing the Live Video Stream
12