memory modules into sockets until the socket levers click into place.
Important:
Do not apply pressure at the center of the memory module. Apply pressure to
both ends of the memory module evenly.
Note:
If you are installing both the AI NVR Performance Upgrade Kit and the AI NVR Standard 10GbE
Kit (AINVR-STD-10GBE) in the AI NVR, use the using the instructions in the "Installing the 10GbECard
in Slot 3 of Expansion Riser 1" section of the
AI NVR Standard 10GbE Kit Installation Guide
, which
includes instructions to install the GPU card provided in this kit, to complete the installation of both
kits.
4. Removing the Pre-installed GPU Card
1. From the back of the AI NVR, locate where the original GPU card is installed.
2. Lift the expansion card latch to release the slots in expansion riser 1.
3. Disengage the PCIe card holder latch on the GPUcard.
4. Hold the GPU by its edges and slide out the GPU at an angle to release it from the connector on the
riser.
4. Removing the Pre-installed GPU Card
13
