Avigilon 11MP-HD-PRO-C, Operating And Installation Instructions

Page: 11 / 24

11
To detach a lens, complete the following steps:
While pressing the lens release button, turn the lens counterclockwise until it stops.
Remove the lens from the camera.
Immediately mount another lens or a dust cap on the lens mount to prevent contamina-
tion.
Caution
Never touch the image sensor or any glass elements inside the lens mount ex-
cept with the recommended cleaning apparatus.
Do not allow dust, moisture or any other foreign debris to enter the lens mount.
Avoid leaving the image sensor exposed for extended periods of time.
Always cover the image sensor with either a lens or a dust cap.
•
•
•
•
Mounting the Camera
Camera mounting points are provided on both the top and bottom of the camera body. Use
these mounting points to mount the camera on a bracket, in an enclosure, or on a tripod.
The mounting points have 1/4”-20 UNC threaded holes which allow them to accept standard
photographic mounting bolts.
Warning
– Use only UL listed mounting bracket suitable for the mounting surface
and minimum 1.15 kg (2.5 lbs) weight, plus the weight of attached lens.
Caution
– This camera is designed for indoor use only. For outdoor use, a suitable
UL listed outdoor enclosure rated type 3 or better shall be used.
Connecting Power
If the camera will be connected to a network that supplies Power over Ethernet, then the
steps in this section are not necessary. If Power over Ethernet is not available, the camera
needs to be powered via the removable terminal block on the rear of the camera.
The camera can be powered from 24VAC or 12VDC. The power consumption specifications
are located in the section titled “Specifications”.
When selecting the wire used to provide power to the camera, be sure to select a gauge that
is heavy enough for the wiring distance. Maximum wiring distances for 24 VAC and 12VDC
power supplies and different gauges of wire are provided in the table below.
1.
2.
3.