a. If the Ethernet cable is uncrimped, push the cable through the grommet.
b. If the Ethernet cable is already crimped, place the grommet piercing cap on the Ethernet
connector then push the cable through the grommet.
Ensure that the orientation of the cable and grommet matches the one shown in the image.
Using the Surface Mount Adapter
The dome camera is provided with a surface mount adapter that can be mounted to a wall, ceiling or electrical
box.
If the dome camera needs to be installed in a different way, use one of the other mounting adapter options and
refer to their installation manuals for more information.
l
In-ceiling mounting adapter (H4SL-MT-DCIL)
l
Pendant NPT mounting adapter (H4SL-MT-NPTA)
o
Pendant wall mounting adapter (CM-MT-WALL) — must be used with NPT mounting adapter.
Mounting the Dome Camera Using the Bottom Cable Entry
Perform the following steps if the required cables will be coming from inside the mounting surface and the
camera will be mounted immediately over the cable hole. Use this procedure on surfaces that can be easily
drilled into, and when the cables should be kept out of sight.
Perform the following steps to mount the dome camera to a ceiling or wall:
1. Use the mounting template to drill 4 mounting holes into the mounting surface and drill the cable entry
hole.
2. Pull the required Ethernet cable through the cable entry hole.
Make sure the Ethernet cable is threaded through the sealing grommet from the camera base. For more
information, see
Inserting Cables through the Sealing Grommet
on the previous page
3. Drive 4 screws to fasten the mounting adapter to the ceiling or wall.
Using the Surface Mount Adapter
8
