Chapter 11: Aux Sends
91
To control panning of Aux bus pairs from Channel Control:
1
Press the Aux Sends switch (1-8 or 9-16) in the Channel
Control section to bank Channel Control to those Auxes. For
linked bus pairs:
• Odd-numbered rotary encoders control send level
• Even-numbered rotary encoders control send pan
2
Turn the even-numbered rotary encoders in the Aux Sends
section to adjust the corresponding send pan.
Using Flip to Faders to Access Send Level and Pan
Simultaneously
You can use Flip to Faders mode to bring Aux level control to
the input faders while retaining control of Send pan from the
input encoders.
To access Aux Send level and pan simultaneously:
1
Assign the input encoders to Aux Sends by doing either of
the following:
• Press a Send switch in the Input Encoder Assignment sec-
tion to assign the encoders to control level for the se-
lected send.
• Target an Aux bus by selecting it in the Output section.
2
Press the Flip to Faders switch, at the bottom of the Input
Encoder Assignment section. The input faders now control
and display level for the selected send, and the encoders dis-
play and control Send pan.
Setting Aux Send Pan to Follow Channel Pan
Panning of the input signal can be set to follow the pan or bal-
ance values of the Input Channel or FX Return feeding the
Aux bus
To set the Aux Send pan to follow Channel pan:
1
Go to the Options page and click the
Busses
tab.
2
On any linked bus pairs, select the
Follows Channel Pan
op-
tion. This setting is applied globally to the corresponding Aux
Send.
Managing Aux Bus Assignments
Viewing Aux Bus Assignments
When an Aux bus output channel is targeted on-screen, its
members are shown in a list on the right side of the Outputs
page.
To view input assignments to an Aux bus:
1
Go to the Outputs page.
2
Target an Aux bus output channel by selecting its on-screen
channel fader strip. Input channels routed to the selected bus
are displayed in the Members list on the right side of the page.
To go to any assigned input channel from the Outputs page:
Click the name of the input channel in the
Members
list.
Resetting Aux Bus Assignments
You can remove input assignments from Aux bus output
channels on-screen.
To remove an input assignment from an Aux bus:
1
Target the Aux bus output channel you want to change by
selecting its on-screen channel strip.
2
In the list of member input channel assignments, right-click
the input assignment you want to remove and choose
Unas-
sign.
To remove all input assignments from an Aux bus:
1
Target the Aux bus output channel you want to change by
selecting its on-screen channel strip.
2
Click the pop-up menu at the bottom of the Members list
and choose
Reset Mix
.
You can link the ACS Aux Sends section to follow AFL, let-
ting you immediately access send controls for Auxes and
Variable Groups by soloing any Aux or Group output strip.
For more information, see “Auxes Follow AFL and AFL Fol-
lows Auxes” on page 112.
Aux bus assignments shown in the Outputs page
Currently selected output
Input assign
pop-up menu
Member
input
channels
courtesy of
www.sxsevents.co.uk
Phone: 0870 080 2342
email: [email protected]
Event production and Audio-Visual Services
www.sxsevents.co.uk