Avid Technology Nitris, Using Manual

Page: 18 / 58

18
SD Video I/O Board Connectors
The following figure shows the connections on the SD video I/O board. The following table
describes the function of each connector. You select which inputs to use from the Capture
tool when inputting.
SD Video I/O Board Connectors
All analog video outputs are available during capture and playback to be used as a client
monitor.
ANALOG IN ANALOG OUT SDI DAE LTC
SYSTEM
MONIT
O
R OUT
Y SD SYNC PB PR Y
PB PR IN
CV 1
CV 2
OUT 1
OUT 2 OUT
2
1
IN
CV S-VIDEO
S-VIDEO
11
19 18 13 21
1 2 3 4 5 6
7 8 9
12
14
15 17
10
16
20
SD Video I/O Board Identifiers
Number Label Function
1 SD SYNC Standard-definition video reference (REF) input for a black burst or
reference signal, BNC connector.
2 ANALOG IN, Y
(component) SD analog component video input, Y luma, BNC connector; connects
to the Y video output of decks.
3 ANALOG IN, PB
(component) SD analog component video input, PB color difference signal, BNC
connector; connects to the B-Y video output of decks.
4 ANALOG IN, PR
(component) SD analog component video input, PR color difference signal, BNC
connector; connects to R-Y video output of decks.
5 ANALOG IN, CV
(composite) Composite video input, BNC connector. Connects to analog video
output of decks.
6 ANALOG IN, S-VIDEO S-Video input, 4-pin connector. Connects to analog video output of
decks.
7 ANALOG OUT, Y
(component) SD analog component video output, Y luma, BNC connector;
connects to Y video input of decks. The component analog output
connectors can also be connected to a monitor or
waveform/vectorscope.